Russian Journal of Transport Engineering
Russian journal of transport engineering
           

2018, Vol. 5, No. 4. - go to content...

Permanent address of this page - https://t-s.today/en/08sats418.html

Метаданные этой статьи так же доступны на русском языке

DOI: 10.15862/08SATS418 (https://doi.org/10.15862/08SATS418)

Full article in PDF format (file size: 402.3 KB)


For citation:

Stroev D.A., Sizonets S.V., Kazaryan V.A. Strengthening the pavement bases through the use of stabilizing additives. Russian Journal of Transport Engineering. 2018; 5(4). Available at: https://t-s.today/PDF/08SATS418.pdf (in Russian). DOI: 10.15862/08SATS418


Strengthening the pavement bases through the use of stabilizing additives

Stroev Dmitry Alexandrovich
Don state technical university, Rostov-on-Don, Russia
E-mail: mr.stroev@mail.ru

Sizonets Sergey Vladimirovich
Don state technical university, Rostov-on-Don, Russia
E-mail: sizonez@rambler.ru

Kazaryan Vanik Abgarovich
Don state technical university, Rostov-on-Don, Russia
E-mail: Vanik-kazaryan@mail.ru

Abstract. The experience of recent years of road operation shows that one of the ways to reduce the accumulation of residual deformations in the layers of road construction, expressed in rutting, the appearance of a grid of cracks and other types of transverse and longitudinal irregularities, is used in the base layers of pavements reinforced with mineral binders of crushed-stone-gravel-sandy mixtures (HGPS). The strength and deformability of hardened HGPS is determined mainly by the structure and properties of the cement stone, which holds the aggregate grains in place. The structure and properties of reinforced HGHPs depend on: the mineralogical composition, the water-cement ratio, the fineness of the cement, the age, the preparation and hardening conditions, or the addition of additives. With the introduction of additives, you can significantly change the strength and deformability of reinforced HGPS.

Currently, stabilizing additives are widely used, the introduction of which allows to provide high water resistance, crack resistance and durability of the structural base layer. At the same time, a reinforced mixture with the use of additives has not only all the positive properties of HGPS on portland cement, but also eliminates its negative sides: low values of compressive strength, tensile strength in bending, and large shrinkage deformations. Based on the above, the introduction of stabilizing additives in fortified HGPS seems to be fruitful.

As an additive, the stabilizer «ARMADOR» was used. The additive is a dry bulk mixture based on polymers, salts of alkali and alkaline earth metals. With the introduction of the stabilizer «ARMADOR», the physico-mechanical parameters increase in the composition of the reinforced material. This stabilizer creates strong crystallization and coagulation bonds, the use of which is recommended in conjunction with a mineral binder.

Keywords: fortified crushed stone-gravel-sand mixture (HGPS); stabilizing additive; physical and mechanical characteristics of the fortified mixtures; the composition of the mixture; compression strength Rcompr; tensile strength in bending Rbend; fatigue strength Rbend/Rcompr

Download article in PDF format

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 License.

ISSN 2413-9807 (Online)

Dear readers! Comments on articles are accepted in Russian and English.
Comments are moderated and appear on the site after verification by the editor.
Comments not related to the subject of the article are not published.

Добавить комментарий